Installing this kit is very simple. Just remove one bolt at a time and replace it with the correct bolt and washer from the kit and tighten. All component kits are seperated and clearly marked as to where they go.
These bolts are great looking and will not rust.
This kit consists of the following individually packaged and labeled component kits:
Point Cover, Dynamo Cover, Intake & Exhaust Flange Nuts, Cylinder & Cylinder Head, Left-side Crankcase Cover, Right-side Crankcase Cover, Oil Filter Cover, Kick Start and Shifter Pinch Bolts.
We use Allen bolts with our custom made washers for proper coverage to replace the old stock panhead screws. We use Socket flathead screws to replace the Ovalheads so the new bolts all match in appearance.
These fasteners have been through our polishing process and the finish is much brighter than a standard stainless steel bolt.