See below for plug wires.
Check the resistance of the coils you are replacing to ensure a correct match.
If you have questions if these are correct- please call us or Dynatek at 1-800-928-3962
Never select a coil with a lower resistance than your ignition system - this will cause the coils to overheat and burn out... It is OK to select coils with a slightly higher resistance. For example 3.0 ohm coils with a 1.5 ohm CDI ignition. While this isn't optimal- it works and allows you to switch your CDI ignition over to a Dyna-S in the future.
Mount spacing center-to-center: 3.5" (90mm)- or 4" (102mm).