Free Shipping - US orders over $100. Canada over $199. See details.

Spark Plug Wire - 8mm - Suppression Core - Gray - Dyna

Spark Plug Wire - 8mm - Suppression Core - Gray - Dyna

Quick Overview

Spark Plug Wire - 8mm - Suppression Core - Gray - Dyna



OEM: DW800 - GREY 8mm suppression core - set of 4 wires with plug caps- rubber boots and connectors Supplied as two wires with plug caps on either end. Cut the wires in half and trim to size required. Dynatek "Dyna" Wires are available with a solid copper core for use on older vehicles where electrical interference is not an issue. For use on new vehicles with electronic advance ignitions or other sensitive electronic equipment use DYNA suppression wires with a high grade graphite core for best performance and electrical noise suppression. Both wire types ensure maximum energy transfer. These wires come with a straight snap boot for easy installation. See below for spark plug wire crimping tool DO NOT USE SUPPRESSION WIRES WITH RESISTOR PLUG CAPS

DYNA WIRE INSTALLATION INSTRUCTIONS 1. Install terminal nuts (supplied) on spark plugs. 2. Attach a wire to each spark plug and route them to the ignition coil. 3. Cut each wire to the desired length and slip a coil boot over the end. (Silicone spray helps.) 4. Strip 3/8" of the jacket and insulation- bend the remaining conductor (copper wire) back over the jacket. 5. Place a clip on the wire so that it makes contact with the conductor. The end of the cable should come to the hole in the clip. 6. Crimp the clip onto the wire with a crimping tool or pliers. 7. Insert wire assembly into plug tower on coil- slide weather resistant boot over clip and plug tower.

Technical Details

Motorcycle Make Honda


Write Your Own Review

You're reviewing: Spark Plug Wire - 8mm - Suppression Core - Gray - Dyna

How do you rate this product? *

1 1 star
2 2 star
3 3 star
4 4 star
5 5 star